- Catalog Home
- Performance/Engine/Drivetrain
- Ignition
- Ignition Wire Harness
Ignition Wire Harness
- Use this harness to run a carbureted setup on 2006-08 Hemi
- Replacement Mag Pickup Harness
- Used to connect your MSD to a distributor or crank trigger
- CAN-Bus Extension Harness
- Connector J1A/B Input/Outputs Auxiliary Harness
- Replacement Ignition Wire Harness
- Easily install two DIS-4 Ignitions on late model Ford Engines
- Easy Connections w/No Splicing Or Cutting Into Factory Wiring
- Wiring the system will take only an hour
- Dominator EFI Connector J2A Auxiliary Harness
- Dominator EFI Connector J2B Auxiliary Harness
- Easily install two DIS-4 Ignitions on late model Ford Engines
- Easy Connections w/No Splicing Or Cutting Into Factory Wiring
- Wiring the system will take only an hour
- Allows For An Easy Conversion
- Easily Connect 6LS To Factory EFI System LS-2/LS-7
- Take Advantage Of Timing Adjustments And Settings
- Emits Clear Signal To Power Grid For Individual Cylinder Timing
- Supplied With Yellow Sleeving For Protection
- Length 12 Feet
- Adapt the MSD Timing and RPM Controller PN[6010] to an EFI system
- Manage the ignition timing and program rpm limits.
- Connects to the factory crank trigger and other sensors.
- Programmable via a PC through MSDs Pro-Data+ software
- HEI Ignition Harness
- Designed To Plug And Play
- Allows Customer To Run A Timed Sequential Fuel Strategy
- Plug-In Harness w/Color Coded Wires
- No Cutting Or Splicing
- Quick Easy Installation
- Provides A Direct Plug-In Installation
- When Adding An MSD Ignition Control
- Provides Splice Free Installation
- Connectors Plug Directly To The Factory Units
- For Digital 7 Ignition Controller
- Direct Replacement
- Duplicate Those Included With MSD PN[8000]
- Lengths And Connectors To Be Assured Of Reliable Performance
- Corrects check engine light
- Main Power Ignition Harness
- Tap Tool
- Labeled For Different Engine Types For GM/Ford Cylinder Banks
- Spark Energy For Maximum Fuel Burn During Combustion Sequence
- Built-in Igniter For Compatibility With Holley Efi
- Maximum Operating Voltage Of 17 Volts
- Compatibility With Both 12 Volt And 16 Volt Electrical Systems
- Direct Bolt-on To Holley Cast Aluminum LS Valve Covers
- Available In Red Or Black To Match Your Build
- Replacement Harness For PN[7730]
- Matching Connectors And Wiring
- 2 ft. Long
- Pro-Flo 4 IAC Ignition Harness
- Protect Trigger Signal
- From Distributor./Trigger Pickup
- Pickup Wires Wound Together
- Routed Thru Aluminum Skinned Sleeve
- Sleeve Connects To Ground
- Provides Ground Shield
- 6 Foot; Matching 2-Pin Connectors
- Great w/MSD Digital Ignition; EFI Racing Systems
- Ford TFI Ignition Harness
- Use w/Avenger EFI HP EFI Dominator EFI Systems
- For Use With Holley Hp Or Dominator Ecus
- Additional Amp Relay To Power Individual Coils